580 A

• Trailed bale wrapper 
• RDS expert controller
  
• Fully automatic radio remote control - optional
  
• End tip kit - optional
  
• Dual stretch dispenser (70% & 55%)
  
• Film roll holders
  
• Film changeover
  
• Film adaptor - optional
  
• Film break sensor - optional
  
• Bale stop roller
  
• Extendable axle
  
• Full width belt
  
• Hydraulic cut & start
  
• Autostop
  
• Turntable support rollers
  
• Dispenser gears (33%) - optional
  
• Adjustable self loading arm
  
• Hydraulic offloading ramp flow control (suitable for all conditions)
  
• Wide low pressure tyres - optional
  
• Closed centre plug – optional
  
• Closed centre tap plug (on/off) - optional

Standard Equipment

RDS Expert Controller
RDS Expert Series allows full automation of bale wrapper as all functions are controlled through electro-hydraulic valves.

Dual Stretch Dispenser
Aluminium dispenser maintains consistent stretch as well as allowing a quick changeover of stretch levels from 55% to 70%.

Film Roll Holders
Additional film rolls can be stored and transported on the bale wrapper.

Film Changeover
Film rolls can be easily loaded into dispenser unit with unique locking mechanism, saving time and effort.

Bale Stop Roller
This acts as a bale stop when loading.  During wrapping, this ensures the bale stays in the same position when being rotated.

Extendable Axle
Trailed wrappers have an extendable axle that eliminates the need for counterbalance weights.

Full Width Belt
Full width belt ensures uneven bales are properly supported and given an even rotation and wrap.  Also minimises loose grass falling down to central spindle.

Cut & Start
Hydraulic cut & start unit holds the film at the beginning of the wrapping cycle and cuts it at the end.

Autostop
The bale wrapper runs through the wrapping cycle and automatically finishes after a set number of rotations, ready for off loading.

Turntable Support Rollers
Turntable supported by four rollers which disperse the weight of the bales over the entire machine, dramatically increasing the lifetime of the machine.


Optional Equipment

Radio Remote Control Unit
The new hand held radio remote control kit simply requires the operator to be within 50m of the wrapper.

End Tip Kit
Allows for the silage bale to be dropped onto its flat side when unloading.

Film Adaptor
Extension for using 500mm plastic.

Film Break Sensor
In the event of a roll of film running out of plastic or breaking during the wrapping cycle, the operator is automatically alerted.  On bale wrappers with two rolls of film, the wrapping cycle speed is automatically reduced when one roll is still operational, ensuring the correct overlap and allowing the operator to finish the cycle until the plastic roll is replaced.  The electronic controller will resume where it left off in the event the operator needs to change the plastic roll during the wrapping cycle.    

Dispenser Gears (33%)
Dispenser gears to allow 33% stretch level.

Wide Low Pressure Tyres
Reduces rolling resistance. Gives larger contact area with the soil, spreading the load over a bigger area.

Closed Centre Plug
Hydraulic plug for closed centre hydraulics.

Closed Centre – Open Centre Tap Plug
Hydraulic plug with a tap to switch from closed centre to open centre hydraulics, if wrapper is to be used on tractors that use either hydraulic arrangement.